Deluxe Balsa Stripper Sheet Stick Slicer - Uses Standard Single Edge Blades R

Description

Deluxe Balsa Stripper Sheet Stick Slicer  - Uses Standard Single Edge Blades R
Tired of high priced balsa sticks? Make your own sticks from sheets using this tool. This is not small under sized slicer. See the specs!
This is a right hand tool, pull with your right hand.
Metal hardware to hold the blade and adjuster, no plastic holes to strip out like some other small hard to use under sized slicers.
Slices balsa, and foam board up to  5/16" thick
Cuts up to 1-1/4" wide
No special blades to buy, uses replaceable single edge razor blades that have a double use . . When one side becomes dull just rotate 180 degree.
One blade included and installed
Save money by slicing your own sticks from sheets.
Fully assembled ready to use
Made using 3D Printing technology
Specs:
Width open:
5-3/8"
Max Cutting width:
1-1/4"
Width Closed:
4-3/4"
Use caution when using this slicer, It has a very sharp blade and can cause injury. When not in use slide the blade holder back to the closed position. (the
position it is shipped in)
Ruler is for reference only and not included.